Set the TV Type selection to match your display aspect ratio and letterboxing preferences when viewing HD material (which will be downconverted for your TV). This will guarantee you can always see the menus. If your display is not HD capable, then set HDMI/YPbPr OUTPUT to 480i. Which HDMI/YPbPr Output Setting Should I Use? Passes through the native resolution of the current channel to the TV set (this could be 1080p, 1080i, 720p, or 480i). The only channels and programs Comcast broadcasts at 1080p are: 3D channels, 3D programs on VOD(Video On Demand), and some PPV events/specials.Īlternates 1080 and 80 i. The rest of the DCX Models can when selected to this resolution will display content at 1080p30 or 1080p24 when content is broadcast at 1080p. NOTE: This option is available only on DCX models with an HDMI cable hookup, but the DCX3501(Comcast Calls the Box the RNG200N)/DCX3510 can upscale all HiDef signals to 1080p60. If you are using the RF, composite, or S-Video output, the video may go blank until you go back to 480i.Īlternates Ypp and OUt to show you are on that settingġ080p at 60 frames per second (for 1080p60), 1080p at 30 frames per second (1080p30) or 1080p at 24 frames per second (for 1080p24)ġ080p60 (only available on the dcx3501/3510) or 1080p30 or 1080p24 WARNING: As you scroll through the options, the output will change to that format. WARNING: If HDMI/YPbPr OUTPUT is set to anything other than 480i, and you are watching HD material, you will NOT be able to see the on-screen menus on the RF, composite, or S-Video outputs. Recordings are ALWAYS saved in their native format. This is only done when on playback or viewing live video. Any source that is 720p or 480p will be converted to 1080i. For example, if you set it to 1080i, all HD will be output as 1080i. The RF, composite, and S-Video outputs will ALWAYS be 480i. HDMI/YPbPr OUTPUT sets the HD format used by the component, DVI, or HDMI outputs. HD will be downconverted with the sides cut off. HD will be downconverted with letterboxing.įor 4:3 displays. HD will be displayed in its native format.įor 4:3 displays. This only appears to affect how HD material is displayed when downconverted to 480i ( SD) or 480p ( ED).įor most widescreen displays. TV TYPE is where you specify the screen format. If you tune into a SD channel before turning off the DVR, the user settings menu will display in standard 480i TV Type If you are unable to see the video on your display, most of the options will also display on the front panel of the DVR. To exit, press the Power key on the remote or the front of the DVR. The left and right arrows will change the selected option. While in the menu, the up or down arrows move between options. Repeat the steps above but leave the DVR unplugged longer.
0 Comments
Leave a Reply. |